Zhecheng Hongxiang Superhard Material Co.,Ltd


Home > Knowledge > Content
Products Categories
Contact Us

Address: Changchun Road 11 National University Science Park Development Five Floor A Block 1103, Zhengzhou, Henan
Contact: Shao man
Mob: 86-13613801611
Tel: 86-371-86038278
Email: admin@toolshnhongxiang.net

Requirements for installation and use of alloy diamond saw blades
Apr 26, 2018

The equipment is in good condition, the spindle is not deformed, no diameter jump, the installation is fixed firmly, no vibration, etc. Check whether the diamond saw blade is damaged, the tooth type is intact, the sawing board is smooth and smooth, and there are no other abnormal conditions, so as to ensure the use of safety. When assembling, determine the direction of the diamond saw blade in the direction of rotation direction of the main axis of the facility equipment.

Axis of diamond saw blade when installation should keep, chuck and clean flange, flange diameter agree with diamond saw blade diameter, closely integrated to ensure flange and diamond saw blade, packed fine accurate positioning pin, tighten the nut. The size of the flange should be appropriate, and the outer diameter shall not be less than 1/3 of the diameter of the diamond saw blade.

Facilities before moving to ensure the safety of cases, a single operating facilities, idle running, check facilities to correct, with and without vibration, diamond saw blade installed first idling for a few minutes, without sliding and swing or normal work after beating. Work, artifacts should ensure that are fixed, the profile of fine accurate positioning completely conforms to the turning direction, so as not to cause abnormal, not to the lateral pressure and curvilinear cutting, feed to smooth, avoiding the blade impact contact phase close to the workpiece, a direct result of diamond saw blade broken, or artifacts, there was an accident.

At work, when the sound and vibration are abnormal, the cutting surface is rough, or when the smell is produced, it is necessary to terminate the operation, check it as soon as possible, and eliminate the malfunction to avoid the accident. In the beginning of cutting and stopping cutting, not to feed too fast, avoid causing broken teeth and damage. If the aluminum alloy or other metal is cut, special cooling lubricant should be used to prevent the diamond saw blade from overheating, resulting in the paste tooth and other damage, which will affect the quality and quality of the cutting products. The facilities and equipment are used to ensure the smooth flow of debris and dregs, so as to prevent the slag from forming into blocks, which will affect the production process and safety. When dry cutting, please do not cut continuously for a long time, so as not to affect the service life and cutting good effect of diamond saw blade; Wet slice cutting, should add water cut, beware of leakage.

Related Industry Knowledge